FPV Drone 1‑2kg payload · 2207.5 1800kV · 2.5W VTX · ELRS 915MHz
1500‑2200mAh 6S · 5‑20km range
FPV Drone Payload1‑2 kg
With load flight time8‑10 minBattery (recommended)1500‑2200mAh 6SImage transmission5‑10 km (open)Flight distance5‑20 kmMax speed150 km/h
FPV Drone Frame – 5‑inch True H
| Structure |
True H |
| Wheelbase |
225 mm |
| Bottom plate thickness |
2 mm |
| Top plate thickness |
2 mm |
| Carbon plate material |
T700 |
| Electronics layer height |
25 mm |
| Arm thickness |
5 mm |
| Camera spacing |
20 mm |
| Stack mounting hole |
M3 * 30.5 mm |
| VTX mounting hole |
M2*20 / 25.5 & M3*30.5 mm |
| Max propeller size |
10.0 inch (frame spec, 5″ props used) |
| Motor mounting hole |
16×16 mm / 19×19 mm |
FPV Drone Motor – 2207.5 1800KV
| KV value |
1800 RPM/V |
| Operating voltage |
3‑6S |
| Configuration |
12N14P |
| Max continuous power |
809 W |
| Internal resistance |
68 mΩ |
| Max current (60s) |
– (not specified) |
| Idle current (10V) |
1.0 A |
| Motor dimensions |
28.7 × 31.3 mm |
FPV Drone Flight Controller – F405
| Size |
37 × 37 mm |
| Mounting holes |
30.5 × 30.5 mm |
| 9V output |
9V regulated, max 2A |
| 5V output |
5V regulated, max 3A |
| 4.5V (receiver) |
USB power only |
| CR |
Current monitoring port |
| M1 |
Camera control pin (depends on firmware) |
| VI |
Camera input port |
| VO |
Video output (VTX) port |
| LED |
RGB LED strip interface |
| B- |
Buzzer negative (B+ for positive) |
| RC |
Receiver SmartPort interface |
| Rssi |
RSSI signal input |
ESC – 50A 6S ( 4IN1)
| Model |
BLHeli_S 4IN1 50A |
| Continuous current |
50 A |
| Burst current (10s) |
60 A |
| BEC |
No |
| Current sensor |
Yes |
| Battery cells |
2‑6S |
| Weight |
21.5 g |
| Size |
37 × 42.7 mm |
| Mounting holes |
30.5 × 30.5 mm |
Camera – GT-E2 Night Vision
| Model |
E2 |
| Image sensor |
1/3″ CMOS |
| Resolution |
1280H × 720V |
| TV system |
NTSC/PAL switchable |
| Menu support |
Yes |
| Image aspect |
16:9 |
| Synchronization |
Internal electronic |
| Electronic shutter |
PAL 1/50‑100,000 ; NTSC 1/60‑100,000 |
| S/N ratio |
>52 dB (AGC OFF) |
| Video output |
CVBS |
| Lens |
2.1 mm / D160 |
| Min. illumination |
0.01 lux @ F1.2 |
VTX – 2.5W 5.8GHz
| Supported voltage |
7‑28 V |
| BEC |
5V / 500 mA |
| Transmission power |
25 mW (13.95 dBm) / 2500 mW (34.04 dBm) |
| Antenna interface |
MMCX |
| Output power modes |
PIT / 25 mW / 2500 mW |
| Standard channels |
40CH (A/B/E/F/R bands) |
| Protocol |
SmartAudio |
| Mounting holes |
20 × 20 mm M2 |
| Size |
25 × 37 × 6.5 mm |
| Weight |
19 g |
Antenna & Receiver
| Antenna model |
Lollipop 4+ Long 150mm |
| Material |
PC-ABS, impact‑resistant double‑sheathed semi‑rigid cable, root reinforcement |
| Receiver (VR) |
ELRS 915MHz |
| Protocol |
CSRF |
| Telemetry output |
<17 dBm |
| Firmware update |
WiFi |
Propellers – T5146 (3‑blade)
| Type |
5146 |
| Blades |
3 |
| Material |
PC |
| Pitch |
4 |
| Center hole inner diameter |
5 mm |
| Weight (set of 4) |
24.5 g (2CW+2CCW) |
Reviews
There are no reviews yet.